Edwards EST IO64GD (64-Point Intelligent FACP w/ Dialer, Gray Door)

This part has been discontinued and replaced by IO64G + SA-DACT The Edwards EST IO64GD is an intelligent addressable fire-alarm control panel in a surface-mount cabinet with a gray door. A factory-installed dual-line dialer reports events in Contact ID format. One Class B or Class A Signature loop supports up to 64 addressable devices, and two Class B notification-appliance circuits provide up to 2.5 A each for system signaling. The panel features a 4×20 backlit LCD for configuration and diagnostics, Genesis strobe synchronization with horn-silence capability, selectable Temporal 3 and Temporal 4 coding, two programmable front-panel switches with LEDs, and Form C alarm and trouble relays. Model Variants: IO64G – Gray door, no dialer IO64GD – Gray door, with dialer IO64R – Red door, no dialer IO64RD – Red door, with dialer IO64-RE – Replacement electronics assembly (main board) Key Specifications: Type: Intelligent addressable FACP Device Capacity: 64 addresses onboard SLC Loops: 1 Class B or Class A Signature loop NAC Circuits: 2 Class B, up to 2.5 A per circuit Auxiliary Power: 24 V DC output for accessories Primary Power: 120 VAC 60 Hz input Battery Support: Supports sealed lead-acid standby batteries in cabinet Communicator: Built-in dual-line dialer (Contact ID) Annunciators: Supports serial annunciators and D16L-iO LED zone expanders Compatible Modules & Accessories: SA-DACT – Dual-line dialer/modem, Contact ID, replacement module SA-232 – RS-232 interface card for printer/PC programming SA-ETH – 10/100 Base-T Ethernet card for remote diagnostics and reports iO-SDC1 – 250-point single-loop controller card for service replacement on IO64 RZI16-2 – Remote zone interface, 16 IDCs plus 2 NACs D16L-iO-1 – 16-zone LED display expander (zones 1–16) D16L-iO-2 – 16-zone LED display expander (zones 17–32) CTM – City-tie module BC-1R – 24 Ah battery cabinet (red) MFC-A – Multifunction accessory cabinet Compatible Detectors & Devices: SIGA-OSD – Optical smoke detector SIGA-PHD – Photoelectric smoke + heat detector SIGA-HFD – Fixed-temperature heat detector SIGA-HRD – Rate-of-rise + fixed-temperature heat detector SIGA-SB – Standard detector base SIGA-IB – Isolator detector base SIGA-RB – Relay detector base SIGA-AB4G – Sounder detector base SIGA-MM1 – Monitor module SIGA-CR – Relay control module SIGA-CC1 – Control module